Mediana P10 Manual de Serviço descarregar pdf (Página 65)

Replacement Level Supported

The replacement level supported for this product is to the printed circuit board (PCB) and

major subassembly level. Once you isolate a suspected PCB, follow the procedures in

Disassembly Guide to replace the PCB with a known good PCB. Check to see if the

trouble symptom persists, swap back the replacement PCB with the suspected

malfunctioning PCB (the original PCB that was installed when you started trouble

shooting) and continue troubleshooting as directed in this section.

Prior to Disassembly

1. Turn off the monitor by pressing the Power Button.

2. Disconnect the monitor from the AC power source.

Fuse Replacement

CAUTION: For continued protection against risk of fire, replace only with the same

type and rating of fuse.

1. After step C6, SMPS disassembly, remove 2 AC power fuses (F1, F2: 250V/3.15A) if

required.

2. Replace with new fuse(s).

3. Reassemble the monitor.

Battery Replacement (A1)

This section describes the steps to remove the battery from the monitor for replacement

without disassembling the main case of the monitor.

1. Remove 4 flat-head screws (2x4) on the rear case.

2. Release lock and remove the battery cover (T4155).

3. Carefully remove the battery and then replace with new battery (Ref.M6028).

4. Put on the battery cover.

Figure 15. Battery Replacement

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 109 110

Sem comentários

Mediana P10 Manual de Serviço Página 65