Mediana P10 Manual de Serviço descarregar pdf (Página 50)

USB download

a. Connect a USB memory drive containing the firmware to the USB port on the left

panel of the monitor.

b. The monitor will automatically run the firmware download once the USB memory is

detected.

TCP/IP download

a. Connect a LAN cable to the LAN port on the rear panel of the monitor.

b. Run the downloading software on the PC.

c. Perform the firmware download according to the software instructions.

4. When Firmware downloading is completed, the completion code will be displayed on

the message line as shown in Figure 13. Refer to Table 14 for descriptions of the

completion codes.

Figure 13. Firmware Downloading Completion

Table 14. Completion Codes

Code Description

I.00.0001 USB is not connected

I.01.0001 USB initializing is completed

I.01.0003 Bad connection for boot download

I.02.0003 Bad connection for main download

S.00.0001 Detected USB

S.01.0001 Boot download & fusing are completed

S.02.0001 Main download & fusing are completed

Note: If there is any problem during Firmware downloading, the error code will be

displayed on the message line. Refer to Firmware Download in the

Troubleshooting section.

5. After completion of downloading, turn off the monitor.

6. Disconnect the USB memory or LAN cable from the monitor.

7. After a few seconds, turn on the monitor again.

8. Check the system version indicated on the copyright screen.

9. Perform the tests specified in the Performance Verification section.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 109 110

Sem comentários

Mediana P10 Manual de Serviço Página 50