Mediana P10 Manual de Serviço descarregar pdf (Página 25)

14. Repeat step 9 to 12.

15. Turn off the monitor.

Note: The accuracy of the monitor’s ECG measurements is ±1bpm. In the procedure, add

the tolerance of the simulator to the acceptable range of readings.

NIBP Operation

These tests verify the functionality of the M30 pneumatic system. The Bio-Tek simulator

or any equivalent NIBP simulator is required to perform these tests. Each of the tests

must be performed to verify pneumatic system functionality.

Over-Pressure Test

1. Connect the cuff hose for adult to the NIBP connector on the monitor’s right panel.

2. Connect the other end of the cuff hose to the NIBP simulator.

3. Set the NIBP simulator to Pressure Relief or Overpressure Test mode.

4. Press the Start Test Button on the NIBP simulator. The simulator will pressurize the

system until the monitor’s over pressure relief system activates.

5. Verify that the peak point displayed on the NIBP simulator (point of protection pressure)

is within 330mmHg. Also, this point of protection pressure may be verified at the

moment of the monitor’s NIBP relief system activation.

The monitor must be placed in the Service Menu to perform the following tests. For a

detailed explanation of how to access the Service Menu, refer to the Service Menu and

Factory Default Settings section.

1. Rotate the jog dial to select NIBP TEST MODE in the Service Menu, and then press

the jog dial.

Note: Before accessing the NIBP Test mode, ensure that current patient mode is proper

for the Pneumatic system to test. You can set Patient mode; Adult/Pediatric or

Neonatal via Setup Menu.

Note: In the NIBP Test Mode, no function button will have no effect except the jog dial. All

tests will start to be performed by pressing or rotating the jog dial. If you would like

to stop the test during test progressing, press the jog dial.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 109 110

Sem comentários

Mediana P10 Manual de Serviço Página 25