Mediana P10 Manual de Serviço descarregar pdf (Página 59)

11. Firmware Download

If an error code appears during the firmware downloading, take the action specified in

Table 16.

Note: If the alarm message still appears, take monitor out of service and contact Mediana

Technical Service Departmentfor advice on remedial action.

Table 16. Firmware Downloading Error Codes

Code Description Action

E.00.0001 USB is not used. Check your USB memory.

E.00.0002 Section.muf file not found or break. Check your USB memory.

E.00.0003 Ver.muf file not found or break. Check your USB memory.

E.00.0004 Update.muf file not found or break. Check your USB memory.

E.00.0005 Binary file not found or break. Check your USB memory.

E.01.0003 Boot download failed. Try downloading again.

E.02.0003 Main download failed. Try downloading again.

E.01.0005 Burn boot failed. Try downloading again.

E.02.0005 Burn main failed. Try downloading again.

E.01.0007 Boot data between SDRAM and

FLASH are not matched.

Try downloading again.

/ Contact Mediana Technical

Service Department.

E.02.0007 Main data between SDRAM and

FLASH are not matched.

Try downloading again.

12. Technical Alarm Condition

When the monitor detects an error condition, the monitor will attempt to show an error

code on the display screen.

If such an error occurs during monitoring operation, the monitor will sound a low-priority

alarm. Audible alarm can be terminated by pressing Alarm silence/suspend switch, but it

depends on error codes and conditions.

Table 17 provides a complete list of error codes and problem identification.

If an error code occurs, take the following actions:

1. Turn monitor off, then on again.

Note: If error code still appears, take monitor out of service and contact Mediana

Technical Service Department or your local representative for advice on remedial

action.

Table 17. Technical Error Codes

Error codes Conditions

EEE001 SpO

module RAM error

EEE002 SpO

module ROM/code integrity error

EEE003 SpO

module bad CRC in communications

EEE004 SpO

module bad communication message

EEE005 SpO

module communication error, incorrect value

EEE006 SpO

module calibration (offset) failure

EEE009 SpO

module syntax communication error

EEE010 SpO

module sensor error

EEE012 SpO

module other hardware problem

EEE017 SpO

module indicator that sensor appears defective

EEE050 SpO

module intermittent error

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 109 110

Comentários a estes Manuais

Sem comentários

Mediana P10 Manual de Serviço Página 59

Comentários a estes Manuais